2026 Honda CR-V e:FCEV Oil Filter in Saint Augustine, FL

The filter captures debris from the oil until it loads and its bypass valve opens. Leaving a loaded filter in place can allow oil to circulate unfiltered.

• Filter matched to the engine's specification
• Drain plug gasket or washer replaced where used
• Filter seal checked after the engine runs

The filter is selected for the engine actually fitted to the vehicle. After installation, the engine is run so the filter seal can be inspected under operating oil pressure.

• Engine-specific filter fitment
• New drain plug gasket or washer where applicable
• Inspection for leaks at the filter seal

The engine can still receive oil, but it may no longer receive filtered oil. An oil-pressure warning or an engine that sounds noisier than usual warrants prompt inspection.

• Debris remains in the loaded filter
• Unfiltered oil may circulate through the engine
• Noise or an oil-pressure warning may need attention

The correct filter fit supports filtration and sealing for the engine installed in the vehicle. Filter selection should be confirmed by the technician rather than assumed from another Honda model.

• Filter fit is determined by the engine installed
• Filters are not interchangeable across engines
• Fitment is checked before installation

Keeping a loaded filter for another change allows debris to remain captured in it and can lead to bypass operation. The manufacturer's schedule and the vehicle's service history help determine the broader maintenance timing.

• Filter replacement accompanies the oil service
• Debris remains in an unreplaced filter
• Service timing follows the applicable maintenance guidance

The service center is located at 2925 U.S. Hwy. 1 South in Saint Augustine, Florida. Booking lets the technician match the filter to the engine and check the seal after the engine runs.

• Online scheduling is available
• Service location: 2925 U.S. Hwy. 1 South
• Filter fitment and post-run leak check are included